筒夾樣式有彈性、止水、剛性攻牙、伸縮攻牙、極小內孔、燒結式熱膨脹可供選擇
彈性筒夾偏擺精度有標準級(0.02mm以內).A級(0.01mm以內).UP(0.005mm以内)
螺帽預設動平衡設計,可在RPM10,000下使用
整支通孔·利於出水及抗震
如需擋刀螺絲可另外指定
裝置時筒夾必須先置入螺帽,再裝入刀具,接著鎖固入本體
刀具置入筒夾內孔,必須超出筒夾內孔有效夾持長度,避免不當鎖固造成損壞
務必使用正確扳手來裝置不可任意改變,避免不當鎖固,造成損壞
There are various features for collet, like flexibility, water sealed, rigid tapping, extend tapping, minimized inner hole, shrink-fitting for your selection.
The ER collet has three kinds of classes for precision: general class 0.02mm,A class 0.01 mm, and UP class 0.05mm.
The pre-balance can reach 10000rpm.
The tool holder is through-hole, whichis better for watertoget through and vibration resistance.
Additional selection if stop screwis needed.
When using, please put the collet into the nut and then put them into the body together.
It must exceed the effective clamping length of collet when inserting the cutter into collet to avoid the improper lock& damage.
please use the right wrench oninstallation to avoid the improper lockand damage.